slot width

An Experimental Study about Relationship between Slot Width and Static Pressure Distribution on Bridge Deck Surface

桥面槽缝对桥梁断面静态压力分布影响的实验研究

互联网摘选

CALCULATING THE EQUIVALENT SLOT WIDTH OF ASYNCHRONOUS MOTOR AT STARTING Research on the Rule of Dimension Decrease in Machining

异步电动机起动等效槽口宽的计算硬聚氯乙烯管铣槽槽口收缩规律的研究

互联网摘选

Under the present test conditions the slot width associated with a relatively low efficiency of moisture removal is found to be 1.0-1.5 mm.

存在一个去水效率较低的缝隙宽度范围，在本试验条件下，相应去水效率较低的缝隙宽度为1.0～1.5mm；

互联网摘选

Influence of Steam Extraction Slot Width on the Flow Fields of Neighboring Steam Turbine Stages

汽轮机抽汽缝宽度对邻近透平级流场的影响

互联网摘选

The arm width and the slot width influence the center frequency as well as the bandwidth.

臂宽和缝宽在影响中心频率的同时也影响带宽；

互联网摘选

Massage slot can make width extent regulation according to leg shape and size;

按摩槽可以根据腿型的精细进行宽窄辐度的调节；

互联网摘选

Two formulas of compound shaper cutter are ob-tained. They are used to calculate the pitch pressure angle of chamfer involute and radius of circle on which chamfer involute starting point lies, and to check the tooth root slot width.

得到了复合插齿刀倒角渐开线分度圆压力角，倒角渐开线起始点所在圆半径的设计公式及插齿刀齿根槽宽的验算公式；

互联网摘选

These analytical results show that the change of the slot width and pole pitch affect the performance of the motors greatly. It also demonstrates that skewing poles could efficiently decrease the torque ripple of PM motors.

分析结果表明，定子槽宽和极宽的变化会对电机性能产生较大影响，永磁电机采用斜极结构，可有效减小电磁转矩波动。

互联网摘选

Determination of Slot Width in A Slotted Pipe for Directional-split Blasting

切缝药包定向断裂爆破切缝管切缝宽度的确定

互联网摘选

Through the lubrication theory modeling, the paper has studied the influences of such technological parameters as gas volume rate, gas slot width and casting speed on the gas film pressure distribution in the gas film soft-contace continuous casting technology.

通过建立铝合金气膜软接触连铸工艺润滑理论模型，分析气体流量、拉坯速度、气缝宽度等参数影响结晶器内气膜压力分布的规律。

互联网摘选

Transverse distance of containers according to a slot width of 2580 mm.

集装箱之间的横向距离是根据箱位宽度2580毫米而定.

网络文摘精选

Using CCD censor to receive the Laser diffraction and measure the precise slot width and round hole radius

利用CCD接收激光衍射的方法测量精密缝宽和圆孔直径

互联网摘选

In this paper, the method to calculate the pole arc coefficient is got. ( 3) The reduction method of cogging torque by different slot width pairing is studied.

本文分析了平行充磁永磁直流电机极弧系数对齿槽转矩的影响，得到了极弧系数的确定方法。（3）分析了不等槽口宽配合削弱齿槽转矩的方法。

互联网摘选

The change rule of winding AC loss with motor slot width and slot height variation is analyzed.

研究了绕组交流损耗随电机槽口宽度和槽口高度的变化规律，对槽内不同位置处的导体交流损耗进行了对比，指出离槽口最近的导体交流损耗最大。

互联网摘选

Using computational fluid dynamics ( CFD) method we studied the critical flutter wind speed of bridge box girder with or without central slot. The results show that the shape of section head and width of slot have large impact on the effect of slot.

用计算流体动力学（CFD）方法研究了箱型桥梁断面中间开槽前后颤振临界风速的变化，结果表明中间开槽的效果与断面头部形状和开槽宽度有密切关系。

互联网摘选

Effect of Suction Slot Width on Water Removal Efficiency for Steam Turbine Hollow Stationary Blades

缝隙宽度对汽轮机空心静叶去水效率影响的实验研究

互联网摘选

Taking water as examples, the velocity of the flow are numerically calculated, and the influences of slot width, slot depth, slot interval and slot number on the velocity distribution are analyzed, respectively.

以水为例，对这种流动的速度进行了数值计算，并分析了槽宽、槽深、槽间距及槽数对速度分布的影响。

互联网摘选

A lower water removal efficiency is obtained for slot width in the range 1.0~ 1.5 mm.

在本实验条件下，相应去水效率较低的缝隙宽度为10～15mm。

互联网摘选

Analyzing the degree of the parameters influencing on heat transfer performance of heat pipe, they are wick diameter, groove number, the slot width and the vapor core diameter.

分析得到了各参数对热管传热性能影响程度，由大到小的顺序为槽道直径、槽道数目、窄缝宽度和蒸汽腔直径。

互联网摘选

Slot length and width of bubble cap

泡罩齿缝长度与宽度

互联网摘选

If other factors remained unchanged, the hole diameter and the slot width increased with decreasing laser energy intensity and increasing nozzle diameter, the machining surface is not plan and the machining depth are slow.

当其它试验条件不变时，喷嘴直径越大，水导引激光能量密度越小，加工孔径和槽宽越大，加工深度越浅，加工的表面质量越差。

互联网摘选

Therefore, it is necessary to raise the gas volume rate while keeping the gas slot width and the casting speed at appropriate levels so as to improve slab quality.

为此，连铸过程中必须采用合适的气缝宽度和拉坯速度，尽可能地增大气体流量，以提高连铸坯质量。

互联网摘选

According to the above algorithm, the paper analyzes the effect of the slot width ( a), length ( b), and depth ( h) on SE and presents its varying graph;

采用上述算法研究孔缝宽度（a）、长度（b）、深度（h）对SE的影响，给出了SE随a、b、h的变化曲线图；

互联网摘选

Maximum bus width of adapter cards that can be inserted into this slot, in bits.

可插入这个插槽的适配卡的以位表示的最大主线宽度。

互联网摘选

Through model experiments, reasonable decouple coefficient range and slot width are gotten, and unsymmetrical dynamic strain field is analyzed.

通过水泥砂浆模型实验，得到了理想的名义不偶合系数与切缝宽度，测试分析了不均匀的动态应变场。

互联网摘选

The factors considered were jet velocity, spacing of nozzle-to-impinging plate ( height), slot width, angle between jet direction and plate, temperatures of impinged plate and water ( liquid) from the slot nozzle.

考虑冲击区对流换热的因素有射流的速度、射流出口距冲击板的距离（高度）、喷嘴的宽度、射流出口速度方向与冲击板之间的夹角、冲击板的温度及水温等。

互联网摘选

Use optical localizer to measure width of inner hole and each kind if slot.

使用光学定位器测量内孔和各种槽的宽度.

互联网摘选

The results show that the central slotting can improve the flutter critical wind speed and there is optimal slot width.

结果表明中央开槽措施能提高颤振临界风速，并存在最优开槽宽度。

互联网摘选

Some parameters affecting the supersonic flowfield, including the total pressure ratio of jet to freestream, slot width of injection, and the angle of injection were studied in more detail.

探讨了射流/主流总压比、射流宽度、以及射流与来流夹角对射流穿透深度、分离距离等影响，揭示了二次射流推力矢量控制干扰流场的控制机理。

互联网摘选

To broach points crumbs slot with design, calculation, slot width runs the number of slots crumbs.

再对拉刀分屑槽进行设计, 分别用公式计算出分屑槽宽 、 分屑槽的个数.

网络文摘精选